Login form

New Product 2009

New Product

TYPE 1 BEARINGS

Designed to be fitted to boats up to 45 feet in length the TYPE 1 bearings feature a spherical Ertalyte� knuckle fitted within a precision machined aluminium housing. This results in a bearing that is simple, light and strong.

type1series

  • The spherical knuckle allows the bearing to self-align while the rudderstock rotates within the bearing.
  • Bearings can be used with both metallic and composite rudderstocks.
  • Bearings are available in any size for 20mm to 110mm in 10mm increments. Knuckles can be bored any size to suit the rudderstock.
  • Bearings are available in three housing styles to suit all installation details.
  • Aluminium bodies are anodised in our in-house anodisation plant to ensure quality and prevent corrosive action.
  • The bearing is non-watertight and is to be installed with either a full between the upper and lower bearing or half rudder tube between the lower bearing and a seal carrier located partway up the rudder stock above the waterline. See installation for further details.
  • Type 1 Bearings are BUREAU VERITAS and CE approved.
 
For improved performance, TYPE 15.XX.XX range, self aligning knuckle is fitted with needle bearings.
95% of the class 40 monohull uses this bearings. Click here for more details.
 
HOUSING STYLES

Type 1 bearings are available with four housing styles:

1010

Type 10.10.XX

This cylindrical bearing is bonded into an aluminium rudder tube. Its small flange is flush with the tube outer diameter.

The bearing can be used as either an upper or lower bearing.

 

 

1011

Type 10.11.XX

The bearing outer surface is machined with one or more grooves to ensure a good bond when the bearing is laminated into the hull.

The bearing can be used as either an upper or lower bearing. One end of the bearing is machined to match the rudder tube.

 

1013

Type 10.13.XX

The bearing is flanged for bolting to the deck.

Lower side of the bearing is machined to match the rudder tube.

Watertight seal or a cap can be supplied on request.

 

 

1041Type 10.14.XX

This bearing is designed for use in production boats. The outer surface is the bearing is tapered for installation in a matching tapered recess.
(See Type 10.14 Installation Guide for details)

The bearing can only be used a lower bearing.

Upper side of the bearing is machined to match the rudder tube.

Watertight seal or a cap can be supplied on request

A specific composite housing can be used for refit or wooden boat (RM range).Click for details. 

 

TYPE 1 DIMENSIONS